November 2019 – Kyle Carmona

ByRon Lindsay December 3, 2019October 11, 2024

Business meeting: new officers elected

Show and Tell table

Ron L. brought 3-sided lidded boxes like Cindy Drozda’s

Al G.

John As.

Rick H.: epoxy filled grooves

Decorative bands

Kyle demonstated his technique for making a segmented bowl with different woods and patterns on inside compared to outside

His full slide presentation can be found in the Members Only section of this website

Kyle uses his own spreadsheet to calculate all the angles and clearances. You may request a copy by emailing Kyle.

A single segment showing typical construction with waste wood

A glued-up ring – Gorilla Glue used for extended setup time

This model shows how segments join together. The bowl is actually built up one ring at a time. This also allows for brick stacking.

Two different cross-sections

Basic stock glued up with PVA glue. He cuts this at various angles on radial arm saw so that laminate joint is parallel to bowl wall.

Pine is used for the waste wood.

Zebrano

Walnut

Hickory

Segment sanding jig. He uses bandsaw to cut segments and then sands to final dimension

Kyle works in decimal so this ruler is essential

Wood raffle: Ash, etc.

July, 2004
Bynstryker@gmail.com December 1, 2004October 11, 2024

Meeting Information: Saturday, July 22 from 9:00 am Noon Jim Rinde: Un-natural Edge Turnings At Levi Mize Woodcraftsman’s Shop 162 Aviador Street #17+18, Camarillo, CA 93010 Aviador Street is N. of the Camarillo Airport and is reached from the Central Ave. exit off of US 101: go S. and turn left on Ventura Blvd. then…

Read More July, 2004
May, 2003
Bynstryker@gmail.com December 1, 2003October 11, 2024

Meeting Information: Saturday, May 24th from 9:00 am to Noon Surface Decoration at Bob Pettit’s Bob will be teaching chip carving and other techniques. Remember to bring a chip carving or similar knife if you have one. The April meeting at Russ Babbitt’s was an outstanding success. After welcoming two guests, Howard Ford and Joe…

Read More May, 2003
June, 2003
Bynstryker@gmail.com December 1, 2003October 11, 2024

NO Meeting in June We will be at the AAW Annual Symposium in Pasadena The next meeting is July 12th The May 24th meeting was held at Bob Pettit’s home (Thanks Mary for the excellent brownies). President Al Geller reiterated our participation in the AAW symposium June 26-29 were we will be responsible for…

Read More June, 2003
January 2014 – Hands-On
ByRon Lindsay January 1, 2014October 11, 2024

Read More January 2014 – Hands-On
June, 2015 – Brad Adams
ByRon Lindsay June 22, 2015October 11, 2024

Read More June, 2015 – Brad Adams
January, 2004
Bynstryker@gmail.com December 1, 2004October 11, 2024

Meeting Information: Saturday, January 24 from 9:00 am to Noon Hands-on Workshop with emphasis on tools and sharpening at Russ Babbitt’s: The first meeting of the year will start us off with a teaching session for new, beginning, and advanced turners to share ideas, techniques, and mistakes we have made or will make. Four lathes…

Read More January, 2004