April 2012 – Robert Craig ByRon Lindsay April 2, 2012October 11, 2024 John A. with his snake in a box Michael I. Michael I. Pedro M. Al describing drying problems with end-grain hollow form Al G. showing clever mallet design built by Greg R. Show and Tell Table cont’d Bruce O.’s tools and turnings in center Robert C.’s segmented show Show and Tell Table – Front four by Ron L. John A. with new library acquisition Pedro M. inquiring about interest in acrylic pen materials Bruce B. talking up the upcoming Fein demo Bruce B. with latest segmented creation Bruce O. Bruce O. with homemade scraper Tucker G. Rick H. Robert Craig Robert C. with slideshow showing his bandsaw technique Slideshow photos – Gluing up stock from three boards Computer-generated cutting template The slider board with T-nut in center Turning stock true between centers Drilling the center pivot hole Cutting the segments Showing the setup in the Cabrillo woodshop Showing the slider board setup Board is pulled through using weights on rope Robert’s son Ed doing the cuts Plenty of help from the peanut gallery The following photos were provided by Robert in August 2012 Lining up the grain
July, 2010 Bynstryker@gmail.com July 1, 2010October 11, 2024 Show & Tell Bring your latest project to share at the 24 July meeting. Ventura County Fair Entries must be submitted July 23-25. Contact Gary Toro to schedule your time in the club booth. The 2010 Fair is from Wednesday 4 August to Sunday 15 August.